• 0

Epoxy Matabro

MATABRO is a mix repair compound consisting of special resin and very hard ceramic saphyre beads from high hardness alumina.


MATABRO is spread with a trowel or a spatula.

20a


Pump casing repairs.

 
21a


Cyclone tile repairs.

 
22a
Pipe elbow repairs.

 

Wearing Compound Matabro

Composition

MATABRO is a mixed compound made of special epoxy resin and very hard ceramic sapphire beads from alumina with a high hardness. The beads are firmly held, and suspended in the compound by the resin. It absorbs wear with a maximum efficiency.

Application

MATABRO is obtained by mixing two measures of resin and one of hardener. You need only to mix the required quantity and the containers can be closed until next use.

MATABRO wearing compound is spread with a trowel or a spatula even on the most difficult application areas. It will fit to any shape such as cones, elbows, etc..
Curing time is about 30 to 45 minutes. MATABRO is ready for use within 3 or 4 hours at 20°C, but by heating the metal with any source, hardening time will be shortened to one hour.

Performance

Laboratory test have shown that MATABRO® is 4 to 6 time more resistant to abrasion than Ni-Hard cast iron. Its resistance approaches the very well known ceramics.
MATABRO® wearing compound chemically resistant to water, solvents and most acids. It also acts as a corrosion inhibiting coating to stop rusting.

Properties

Tensile strength: 5000psi
Compressive strength: 14.500psi
Heat deflection temperature: 155°F
Resistance to chemical products: good

Uses

Return idlers, feed chutes and bores, rod and balls mills, pump casing, dust collectors, cyclones, chute lining, pan feeders, dragline pulleys, feed chutes, pipes elbows, hoppers, etc.

Advantages

  • Very easy to mix and apply, even to difficult shapes.
  • Reduction in down time.
  • Economy in labor.
  • Great longevity.

Volume of material

1 kit contains 2 kg hardener + 4 kg resin and will cover 0.5 sq.m. in 5 mm thickness.